True-induction S2F3 Manuel d'utilisateur télécharger pdf (Page 4)

Building of Supports for Cooktop Below the Counter

-Any thickness of the countertop can be ulized, however, the thickness will determine if the supports are built into the

walls of the cut-out, placed below the cut-out, or be built out from the boom of the cut-out.

-Two support beams between ½” and 1” in width and 2” in depth should be placed lengthwise (spanning 23 11⁄16”) 2 ¼”

below the surface of the cut-out. In order to achieve this depth it may be necessary to add a build out to the 14 ¼” sides

of the boom of the countertop.

-The supports should be spaced center line in from the rear 1 1/4” and the centerline in from the front 2½”.

Installing Cooktop:

-First feed the power wire through the hole and to the locaon of the power receptacle underneath the cabinet.

-The ½” overhang on the inducon cooker comes with pre-installed foam gasket. Peel o the adhesive protector on the

boom of the gasket and set the inducon cooker into the cut-out. Gently press down on the inducon cook top to se-

cure the adhesive gasket to the countertop. The cook top should be sing on the supports previously installed.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

True-induction S2F3 Manuel d'utilisateur Page 4